Hi All

I want to do the stress analysis with inventor 2018, but it's not reasonable to just make a pin constraint for below picture's structure.
Capture1PNG.PNG
so I make a shaft inside the eyes, and make contacts of sliding/ no separation.
but the result confuse me:
The shaft will clash with the hole after I select adjust 1x. I think the shaft should be always aligned with hole. see picture below
Capture.PNG


Two of my question:
1. Does it possible to select the support plate's position (remote), just like Anys?
2. If not, is my way correct? Or how to deal with the solution I occur.