Hi
I've been stuggling to find how to attach 2 Lookup Actions to 1 Lookup Parameter.
I found a DB with an array for a BOM and it had just what I was looking for, (Thx to whoever that was!), so I recreated the elements in the block, using mm sizes, along with all the dynamics I required and it performed just how I wanted, however, the original block has imperial units of 'Inches' so when inserted into a metric drawing it scales up.
Is there a way to change just the blocks units to 'mm'
Also how do you attach 2 lookup actions to 1 lookup parameter, as in the block attached, as I would like to achieve the same dynamics on the horizontal stretch.
Have attached the block.
Hope there is someone out there to help
Thx in advance ........
Geoff
Its ok I've found what I'm doing set bactionbarmode to Zero and all is well!!!!!!