Hi Me Again
Not sure if it's here or Programming Forum to post this!!!
I am trying to use the visibility add lisp routine, I aquired from the web, to add more than one Visibility Parameter but am getting an error after loading the first one .....
Command: VISIBILITY_ADD
Select point for placing Visibility Set: _.point
Current point modes: PDMODE=3 PDSIZE=0.37500000
Specify a point: 0,0,0
Command: ; error: bad DXF group: (360)
Have attached the lisp routine perhaps somebody more clued up than me with lisp routines can have a look!
Thx
Geoff