Hello again, still a newbie and still fighting roofs, attached is a shot of roof not joining, I apologize for the redundancy but I don't know where else to turn, thank you very much
Dallas
|
Hello again, still a newbie and still fighting roofs, attached is a shot of roof not joining, I apologize for the redundancy but I don't know where else to turn, thank you very much
Dallas
You just need to draw the footprint in the overall shape of the roof to the points where the 2 roofs connect as shown in the attached image.
Attachment 108485
Then you can use the join tool to join the roofs. However I would suggest revisiting the roof design as you can see as is it will create a valley with no slope to create proper drainage.
Not a roof expert here. This is a very common issue with roofs, especially when building an extension to your house.