earthen shoulder

[rmk]

what subassembly should I use for an earthen shoulder?
i used the lanesuperelevationAOR for the paving section. all i need beyond that is an earthen shoulder from top of pave1 to the bottom of subbase.
if i use the shoulderextendall or the shoulderextendsubbase and make the top 2 pavements 0, i get a weird looking roadway.
could it be because i'm zero outing the pavement? or is it the snap point for the subassembly.

[Opie]

I don't have it open at the moment, but could you change the link and shape names to match your shoulder area?

[rmk]

I don't have it open at the moment, but could you change the link and shape names to match your shoulder area?

I'm don't know how to do that.

[Opie]

Apparently, you cannot change the link and shape of those areas in this OOTB assembly.

Can you provide a screen shot of your weird roadway?

In testing, I attached a ShoulderExtendSubbase OOTB assembly. Then I zeroed out all paving and base sections and it looks as expected to me.

[rmk]

thanks for the reply. after playing around with it some more, I did what you did and I got it to work as expected.

[Opie]

thanks for the reply. after playing around with it some more, I did what you did and I got it to work as expected.

Good to hear.