How can I move a surface from Surveyors local grid to State Plane Coordinates?
|
|
Moving a surface to Correct grid coordinates
How can I move a surface from Surveyors local grid to State Plane Coordinates?
Re: Moving a surface to Correct grid coordinates
Probably through coordinate transformation. I have not done it, therefore cannot look further into this without sample data.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Re: Moving a surface to Correct grid coordinates
HiOriginally Posted by tim_newsome
you can move the surface with the move command. Couple cautions first make sure you have a copy of the original. Second when you move the surface be very careful you to not change the elevations. I would make sure all points involved are unlocked and surface is unlocked make a block of the surface and all points involved. then use the align command to moved and rotate at the same time.
Posting Permissions
Reply With Quote