Anyone have a contact for a raster to vector conversion back to CAD? I've got a several decade old drawing that is quite busy to update.
Thanks.
|
Anyone have a contact for a raster to vector conversion back to CAD? I've got a several decade old drawing that is quite busy to update.
Thanks.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
This is driving me nuts... I had a service that I used off and on for years, because they did so much better than the team hired by my predecessor and whose work I had to fix for ages... and I cannot for the life of me remember... it's on the tip of my mind... I'm sure I'll wake up at 2am and it'll come to me.
Melanie Stone
@MistresDorkness
Archibus, FMS/FMInteract and AutoCAD Expert (I use BricsCAD, Revit, Tandem, and Planon, too)
Technical Editornot all those who wander are lost
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
R.K. McSwain | CAD Panacea |
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Nope! It came to me! lol. I just didn't log in at that moment to share.
Melanie Stone
@MistresDorkness
Archibus, FMS/FMInteract and AutoCAD Expert (I use BricsCAD, Revit, Tandem, and Planon, too)
Technical Editornot all those who wander are lost
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
It took a couple of days and the results were acceptable. A few issues here and there. I'd use them again.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Melanie Stone
@MistresDorkness
Archibus, FMS/FMInteract and AutoCAD Expert (I use BricsCAD, Revit, Tandem, and Planon, too)
Technical Editornot all those who wander are lost
I am also. However, you were the only source with a recommendation. Even our plotter sales people didn't have a recommendation.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt