Hello, everyone,
probably nobody ever uses Fabric sheets, or I am bad with understanding, but what I have now:
I create Wall.
Then, I create Fabric sheet Area with Pick line tool.
Check cover settings in plan - it's equal to 25 mm.
cover in plan.png
Make a section and check cover - it's 20 mm.
cover in section.png
Maybe it's not my day today, but I don't really understand what am I doing wrong?
Actually, if I draw boundary by line (not Pick line), I get correct covers. So, I would rather say something is wrong with the software!
Actually mesh is in a good position, but if you try to measure it, dimension shows wrong value. You can see here I have two 25 mm values, which is measuring different distances and they are not overwritten.
actual dimension is 20, but it shows 25.png
Anyone had this issue?