Results 1 to 2 of 2

Thread: Placing point loads on plates and getting results

  1. #1
    100 Club
    Join Date
    2016-04
    Location
    California
    Posts
    149
    Login to Give a bone
    0

    Default Placing point loads on plates and getting results

    Hello.
    I have a edge supported steel deck plate and I have placed 2 point loads on it. When I run Verification i get no errors but when I run the analysis I get the attached error and no results (all load effects = 0)
    Why?
    Also I used a fixed line support along the long edges but when the plate was meshed the support symbols changed, for what it is worth.
    Thanks,
    TT
    Attached Images Attached Images

  2. #2
    100 Club
    Join Date
    2016-04
    Location
    California
    Posts
    149
    Login to Give a bone
    0

    Default Re: Placing point loads on plates and getting results

    As a follow up, I generated some results but the only values I have is for deflection, the plate stresses are still showing zero (in red type lower right). See attached screen shot.
    TT
    Attached Images Attached Images

Similar Threads

  1. CV104-1P: One Point, Two Point, Red Point, Blue Point
    By Autodesk University in forum Civil Infrastructure
    Replies: 0
    Last Post: 2013-05-05, 03:17 AM
  2. CV12-4: One Point, Two Point, Red Point, Blue Point
    By Autodesk University in forum Civil Infrastructure
    Replies: 0
    Last Post: 2013-04-17, 04:50 AM
  3. 2013: Structural columns and beams- adding base plates and encasing?
    By mikz12345100664 in forum Revit Architecture - General
    Replies: 0
    Last Post: 2012-11-12, 02:07 PM
  4. Clash Batch results show reported results
    By pauljordan in forum NavisWorks - Wish List
    Replies: 1
    Last Post: 2012-05-15, 08:35 PM
  5. Placing insertion point at mid-point of flange on a steel section
    By Spenner in forum Dynamic Blocks - Technical
    Replies: 4
    Last Post: 2007-06-18, 01:53 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •