Hi all
I am sure that this has been dealt with in the past but I cant find the thread.
I have a simple exterior wall consisting of 6mm cement sheet lining on the exterior, 75mm timber stud and 10mm GWB on the inside.
when I create a building and add room spaces, and create an all room quantities schedule. Calculate the room quantities, and all works well.
I cannot find out how to generate a wall schedule to show the net area of the cement sheet on the external walls of the building.
I have added the area_rightnet and area_leftnet to the property sets for the wall. The correct areas show up in the extended data tab in the properties dialog pallet for each wall I select and I could just add them together. But I am at a loss on how to get the schedule to show these area values for each wall and the total area value for the entire exterior of the building.
I'm sure that it is simple, I have looked on line and tried to understand the gobbledegook from the auto-desk knowledge library but none of it works.
I'm sure this has been asked and dealt with many times before. I will be grateful for any help or any links to the solution.
be gentle I'm new to schedules.
Thanks John.