I have a sample line X-Section that is intended to show a proposed culvert.
How do I draw that pipe in the section view?
|
|
|
I have a sample line X-Section that is intended to show a proposed culvert.
How do I draw that pipe in the section view?
Have you added the pipe network to the sample line group as a data source? Does the sample line cross the pipe in any way?
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Q2, Yes, sample line runs in center of pipe.
Q1, Thats the issue. I remember when checking data sources that I did not add it. ( my mind was thinking topo)
Can I add it now?
Yes, you can add it at anytime. In the Sections tab of the Sample Line Group Properties dialog box, click the button to Sample more sources...
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt