Results 1 to 1 of 1

Thread: Polyline out of plane

  1. #1
    Member tuomo.jarvinen's Avatar
    Join Date
    Jyväskylä, Finland
    Login to Give a bone

    Default Polyline out of plane


    1. I draw a basic rectangle
    2. I change to an isometric view.
    3. I change my ucs to "front"
    4. I begin drawing a polyline... problems begins:

    Polyline should appear on the plane in which I am: front.
    But I can't see it right until I give it the second point.
    It's like I have to draw "blind", which is very frustrating.

    Can somebody please help why is this behaviour?
    Earlier such phenomenom didn't exist.

    I use AutoCAD Civil3d 2020.
    Attached Images Attached Images

Similar Threads

  1. Replies: 4
    Last Post: 2010-04-20, 07:55 PM
  2. Sloped Bottom Plane/ Flat Top Plane
    By signalbass in forum Revit Architecture - General
    Replies: 3
    Last Post: 2010-01-06, 10:34 PM
  3. Error: Top clip Plane is set Below the Cut Plane
    By hutch_amit in forum Revit Architecture - General
    Replies: 3
    Last Post: 2008-07-14, 05:11 PM
  4. Sweep Profile plane and Orient by plane
    By dbaldacchino in forum Revit Architecture - General
    Replies: 2
    Last Post: 2006-02-03, 08:00 PM
  5. Mask difference on vertical plane vs. horizontal plane.
    By SkiSouth in forum Revit - Rendering
    Replies: 0
    Last Post: 2004-04-24, 01:08 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts