Results 1 to 2 of 2

Thread: Convert to Surf and Imprint problems

  1. #1
    Member
    Join Date
    2022-02
    Posts
    5
    Login to Give a bone
    0

    Default Convert to Surf and Imprint problems

    Cannot get this closed PLine to convert to surface, or imprint.
    What am i doing wrong?
    i need to get this to a solid so I can mesh and sculpt.
    Thank you in advance
    Attached Files Attached Files

  2. #2
    100 Club
    Join Date
    2000-11
    Posts
    140
    Login to Give a bone
    0

    Default Re: Convert to Surf and Imprint problems

    I hope I can attached a dwg to this. I found the area that is the problem. One small area that you need to redo. Notes are in dwg with some explanation and suggestions. Hope you still need this. I don't see an icon to attach file. I tried drag & drop don't know if it worked. Ridiculous there is no icon to attach a fixed dwg. I see one for an image but need to actually attach a dwg file someone can use. PHOOEY!Spline2Polyline2SolidFixed.jpg If you don't see the dwg and still need it send an email to alaskajackfrost@yahoo.com

Similar Threads

  1. Cannot clean / remove Imprint from Solid in AutoCAD 2007
    By Jack Cheong in forum AutoCAD 3D (2007 and above)
    Replies: 8
    Last Post: 2008-04-22, 11:08 AM
  2. Imprint - seems easy - where am I going wrong?
    By markjohn.perry in forum AutoCAD General
    Replies: 0
    Last Post: 2007-04-30, 09:16 AM
  3. Hatch - Surf pattern problem
    By sbrown in forum Revit Architecture - General
    Replies: 13
    Last Post: 2006-06-06, 03:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •