Results 1 to 2 of 2

Thread: Plan and Profile issue

  1. #1
    Member
    Join Date
    2022-01
    Posts
    8
    Login to Give a bone
    0

    Default Plan and Profile issue

    I am a novice user.

    Project description: 841' water line replacement

    Situation (in short): I created a surface from contours used the center line of a wide single land road - created a alignment then created plan and profile - everything went fine. Boss came back and wanted the proposed water line to be the alignment instead of the CL. (I used the same file - did not recreate) made the Second Alignment using the proposed water line, created a plan and profile BUT this time the grid showed up but not the profile.


    The surface is still in Prospector under surfaces.....the new alignment appears to have been created correctly and is also in prospector.

    Any ideas?

  2. #2
    Administrator Opie's Avatar
    Join Date
    2002-01
    Location
    jUSt Here (a lot)
    Posts
    9,096
    Login to Give a bone
    0

    Default Re: Plan and Profile issue

    Have you created a surface profile for your second alignment? Do you have the profile view station and elevations set to values where the profile should be showing?
    If you have a technical question, please find the appropriate forum and ask it there.
    You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
    jUSt

Similar Threads

  1. Plan and Profile issue
    By faulknerms798721 in forum AutoCAD Civil 3D - General
    Replies: 9
    Last Post: 2022-01-05, 12:26 PM
  2. Replies: 0
    Last Post: 2011-12-09, 11:23 PM
  3. Non-rotation of plan labels on a plan and profile sheet
    By Capt. Computer Crasher in forum AutoCAD Civil 3D - Profiles
    Replies: 11
    Last Post: 2009-01-12, 07:13 PM
  4. Profile Labels / Plan-Profile sheets.
    By jbbarrus in forum AutoCAD Civil 3D - Profiles
    Replies: 1
    Last Post: 2006-11-10, 07:35 PM
  5. Titleblock - issue date and type of issue placed in issue column
    By jdrexler in forum CAD Management - General
    Replies: 4
    Last Post: 2006-04-10, 05:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •