See the top rated post in this thread. Click here

Results 1 to 2 of 2

Thread: Sim and Opp Referenced Section Cuts

  1. #1
    Member
    Join Date
    2014-10
    Posts
    17
    Login to Give a bone
    0

    Default Sim and Opp Referenced Section Cuts

    Hello All!

    I come seeking knowledge in regards to referenced section cuts. With our work flow, we have Curtain Wall frame elevations that have the same jamb details and would like to be able to cut one section and reference it to a detail view and then cut the opposite jamb with the same detail, but have a subscript that identifies it as "Opp". Is this possible or do any of you have an efficient workaround to this situation??


    Thanks in advance!

  2. #2
    Super Moderator CAtDiva's Avatar
    Join Date
    2015-10
    Location
    Where pedals spin to move wheels
    Posts
    441
    Login to Give a bone
    2

    Default Re: Sim and Opp Referenced Section Cuts

    We do these manually. Until detail callouts have the capability to have instance comments, there's really no other option.

Similar Threads

  1. Replies: 2
    Last Post: 2014-04-13, 07:56 AM
  2. Instance Parameter for SIM and OPP on Sections and Callouts
    By Wish List System in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2012-12-10, 02:38 PM
  3. Robot (1 week opp)
    By bal in forum Robot Structural Analysis
    Replies: 0
    Last Post: 2011-07-25, 08:47 AM
  4. wall section/ building section tags/cuts
    By belyo in forum Revit Architecture - General
    Replies: 3
    Last Post: 2006-12-13, 07:39 PM
  5. Cycle through arrowheads sim to section heads.
    By sbrown in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2005-06-02, 06:23 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •