I have a situation that calls for modeling side supply registers on round duct. However, instead of projecting straight out, I need to angle the register at 30 degrees down.
The ideal situation would be to find a register family that allows me to insert it on a duct so that it is flush. However, the family that I found from the manufacturer only allows a horizontal throw. I cannot rotate it after insertion (photo 1).
A second option would be to simply tap the duct with a short run of duct and then insert a register on the end. However, I can do this horizontally, but again, I cannot rotate it (photo 2).
If anyone has a family that will satisfy the ideal situation, I would appreciate it. Otherwise, some direction on how to model the duct at an angle would suffice.
As always, an help would be greatly appreciated.
Side Tap Register_01.jpgSide Tap Register_02.jpg