A vertical vessel with support lugs. even after changing the H dimension, will not move from the bottom of the vessel. Tried using a positive number for H and a negative number for H. It will not accept a negative number for H. Is there a solution to this other than building lugs with Autocad solids?
Autodesk has sent me an email pertaining to this issue. The email gave me a knee-jerk response to tell me to use the ADD TRIM button on the dialog to make a new vessel. I would think that it was obvious that I had already done that because the image has lugs on the vessel.
But besides that, why is AUGI giving my email address to Autodesk? AND, why is Autodesk soliciting me to join their forums and not posting responses here. Is AUGI now a division of Autodesk? I use to get all the answers I need here on AUGI forums. Autodesk would only put me on hold or give the same kind of response as the email I just received.