what subassembly should I use to target a surface with a specific slope from the edge of a lane.
I've tried several, but can't find one that targets a surface at a particular slope.
|
|
target surface
what subassembly should I use to target a surface with a specific slope from the edge of a lane.
I've tried several, but can't find one that targets a surface at a particular slope.
Re: target surface
Have you tried the LinkSlopeToSurface subassembly? It is found on the Generic tab of Tool Palettes
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Posting Permissions
Reply With Quote