Aligning Profile to Quatar Pointed Arch Opening

[ljupadhyay]

I need to fit a wooden frame in window opening cut (Quater Pointed Arch). After making sweep along the cut path with frame profile. sweep is successfull, but when I change the dimensions of opening, it ask to remove constraints. So Is there any way to make sweep along its path. Files are attached.
How to remove older attachments to upload current files

[Ed Jobe]

When you reply, click on the "Go Advanced" button. Then click on Manage Attachments to upload a new file. If you are talking about the attachments you previously uploaded, then go to your settings page and click on the Attachments link.

[ljupadhyay]

Thanks Jobe, I have got success to delete my older files. I was unable to use this forum since last many years.
Now attaching the concerning files'

[ljupadhyay]

Finally it is done. For the sweep path, I aligne & lock the straight line path with the wall cut edges but for curve path I align the wall cut curve edge but inspite of locking it to wall cut, I lock their end points to respective vertical R. Planes and it is done. frame is created by 4 profiles &modelled out side the wall & can be placed at desired offset from exterior edge of wall. A Trim is also modelled at exterior of the wall, whos projection is set to zero if not require.

[ljupadhyay]

Now can any user try to nest a single or double leaf multy lite shutter, modeled seperately on a 3D variable swing ?