See the top rated post in this thread. Click here

Results 1 to 3 of 3

Thread: What does "Phasing Filter" do under Phasing for Views?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    I could stop if I wanted to
    Join Date
    2015-08
    Location
    Jacksonville, Fl
    Posts
    274
    Login to Give a bone
    0

    Default What does "Phasing Filter" do under Phasing for Views?

    Revit 2023: What does the 'Phasing Filter' located on the properties pallet under Phasing for views do?

  2. #2
    Active Member
    Join Date
    2009-09
    Location
    New York, New York
    Posts
    80
    Login to Give a bone
    1

    Default Re: What does "Phasing Filter" do under Phasing for Views?

    Hopefully I am understanding your question:
    The Phase Filter that can be assigned to any view allows you display or hide any element of your model, depending when it is created and when it gets demolished.
    It is essential for renovation work, for any work involving a demolition plan.
    It also controls how each element gets displayed in the demolition plan, etc.

    If you go to the Phases tab under Manage tab, you can create (I think an unlimited number) of phases, and phase filters.
    Many people just create Existing and New Construction; then each piece of your model (each door, each window, etc) can be told (using properties) when it gets demolished. Each item is normally created in the phase governing the view in which it was created. There are many good videos about this on Utube.

    This one from the ever-helpful "Balkan Architect" is a great place to start:

    https://www.youtube.com/watch?v=HNRpnLLluEY


    BTW: It can sometimes be an alternative to Revit's Design Options feature. With practice, you can hide small variations on your design in a future phase, and go to that phase if you need them later. It has many uses.

    Hope this answers.

  3. #3
    100 Club
    Join Date
    2015-08
    Posts
    199
    Login to Give a bone
    0

    Default Re: What does "Phasing Filter" do under Phasing for Views?

    Phase Filters allow you to apply specific graphic overrides to the 4 different states (New, Existing, Demolished, Temporary) at which a modeled element can be in depending on its "Phase Created" and "Phase Demolished" parameters.
    The states are defined as:
    1. New - created in the phase the view is set to.
    2. Existing - created in a previous phase than what the view is set to.
    3. Demolished - created in a previous phase and demolished in the phase the view is set to.
    4. Temporary - created and demolished in the same phase the view is set to.


    Phase Filters.png

Similar Threads

  1. A graphic override is required under Phasing for Demolished Phase i.e: Transparency
    By Wish List System in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2011-12-01, 11:09 AM
  2. How does something get stuck under <no level>?
    By RevitNinja in forum NavisWorks - General
    Replies: 5
    Last Post: 2011-07-07, 11:59 AM
  3. Replies: 2
    Last Post: 2006-05-03, 02:01 PM
  4. creating categories under views
    By jeverett in forum ACA General
    Replies: 1
    Last Post: 2004-10-23, 05:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •