hi
something changed and I can't find it. everytime I use a civil3d transparent command like plotting a line by bearings it turns off my snaps. any ideas to fix this
|
hi
something changed and I can't find it. everytime I use a civil3d transparent command like plotting a line by bearings it turns off my snaps. any ideas to fix this
Yes. You would need to reset your osnaps afterwards. For some reason, the developers thought it was a good idea to adjust the user defined settings when using the Civil 3D commands, but then not reset the settings to the assigned settings prior to the command.
Once you set your osnaps, check the OSMODE system variable. The number returned is the number you can then assign the OSMODE variable to your desired setting. The System Variable Monitor (SYSVARMONITOR at the command line) could help notify you when that setting is not as desired.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
hi thanks i'll look at that it's very frustrating it's not consistent sometimes it does sometimes it doesn't