See the top rated post in this thread. Click here

Results 1 to 2 of 2

Thread: Delete a vertical curve

  1. #1
    100 Club JeffClark's Avatar
    Join Date
    2002-07
    Location
    South Jersey
    Posts
    153
    Login to Give a bone
    0

    Default Delete a vertical curve

    There should be a way to delete the vertical curve without deleting the PVI, but we have not found it.

    Sometimes, when designing the vertical, the AMax fallf low enough that the curve in no longer warented, but the PVI is still needed.

    So we write down the station & elevation of the PVI, delete it, then put the PVI back in at the same place it was to begin with.

    You should be able to just remove the curve.

  2. #2
    I could stop if I wanted to
    Join Date
    2014-08
    Posts
    453
    Login to Give a bone
    2

    Default Re: Delete a vertical curve

    hi
    you can just select delete entity on edit geometry toolbar make sure you select the curve not the tangent

Similar Threads

  1. 2019: spiral-curve-spiral s-curve, set tangent to length?
    By Maverick91 in forum AutoCAD Civil 3D - Alignments
    Replies: 2
    Last Post: 2018-07-27, 02:39 AM
  2. 2018: spiral-curve-spiral-curve-spiral-curve-spiral alignment?
    By Maverick91 in forum AutoCAD Civil 3D - Alignments
    Replies: 1
    Last Post: 2018-06-07, 07:33 PM
  3. Is there a way to trim a vertical alignment at a vertical curve?
    By adam.zampino477239 in forum AutoCAD Civil 3D - Profiles
    Replies: 2
    Last Post: 2012-05-09, 05:25 PM
  4. Station Interval in Vertical Curve Profile
    By mdoty in forum AutoCAD Civil 3D - Profiles
    Replies: 2
    Last Post: 2008-01-10, 09:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •