Dynamiic LVLhanger

[cadconcepts]

Hi All
I am working a dynamic lvl hanger. It is sort of working but I cannot figure out why it continues to double up the tabs. I erase the tab in the block and it continues to add to insertions. Not quite sure what I am missing or doing wrong. Any help is greatly appreciated. Thanks.
Manuel

[Opie]

First, I would recommend when posting dynamic blocks for inspection you place the dynamic block into a container drawing first. This will prevent AutoCAD from asking the question of going straight into the block editor. This will allow someone to evaluate the actions of your block before analyzing the properties and actions within the block. However, that is just my recommendation.

Onto your block. Check the Column offset value for your Array action is set to the desired distance (I believe it should be 2). This will remove the duplicate or "double up" tabs you describe.

[cadconcepts]

Opie
Thanks for the recommendations, it helped me solve the problem. Take care.
Manuel