Results 1 to 2 of 2

Thread: Sweeps not mitering

  1. #1
    I could stop if I wanted to
    Join Date
    2003-10
    Location
    Santa Barbara
    Posts
    397
    Login to Give a bone
    0

    Default Sweeps not mitering

    I have placed two sweeps but they will not miter at the corners
    whats up with that?

  2. #2
    Super Moderator beegee's Avatar
    Join Date
    2003-05
    Location
    crusing 11 kms above Australia
    Posts
    5,153
    Login to Give a bone
    0

    Default Re: Sweeps not mitering

    Check that the host walls are properly joined.

    Check that the exterior faces of the host walls face the sweep.

Similar Threads

  1. mitering 3D solids
    By JSSMSM in forum AutoCAD 3D (2006 or below)
    Replies: 12
    Last Post: 2020-07-21, 11:38 AM
  2. Fascia not mitering
    By dzatto in forum Revit Architecture - General
    Replies: 12
    Last Post: 2010-05-04, 02:21 PM
  3. Wall sweeps / mitering
    By gfujka in forum Revit Architecture - General
    Replies: 1
    Last Post: 2009-02-02, 01:55 PM
  4. Mitering fascia sweeps
    By JTAND in forum Revit - Platform
    Replies: 2
    Last Post: 2008-08-29, 04:21 PM
  5. Fascia Mitering Bug.
    By beegee in forum Revit - Known Issues & Work-Arounds (Read only)
    Replies: 0
    Last Post: 2004-01-29, 02:16 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •