Results 1 to 2 of 2

Thread: Sweeps not mitering

  1. 2005-07-10, 10:57 PM #1
    jwilhelm
    jwilhelm is offline
    I could stop if I wanted to
    Join Date
    2003-10
    Location
    Santa Barbara
    Posts
    397
    Login to Give a bone
    0

    Default Sweeps not mitering

    I have placed two sweeps but they will not miter at the corners
    whats up with that?
    Reply With Quote Reply With Quote
  2. 2005-07-11, 12:55 AM #2
    beegee
    beegee is offline
    Super Moderator beegee's Avatar
    Join Date
    2003-05
    Location
    crusing 11 kms above Australia
    Posts
    5,153
    Login to Give a bone
    0

    Default Re: Sweeps not mitering

    Check that the host walls are properly joined.

    Check that the exterior faces of the host walls face the sweep.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. mitering 3D solids
    By JSSMSM in forum AutoCAD 3D (2006 or below)
    Replies: 12
    Last Post: 2020-07-21, 11:38 AM
  2. Fascia not mitering
    By dzatto in forum Revit Architecture - General
    Replies: 12
    Last Post: 2010-05-04, 02:21 PM
  3. Wall sweeps / mitering
    By gfujka in forum Revit Architecture - General
    Replies: 1
    Last Post: 2009-02-02, 01:55 PM
  4. Mitering fascia sweeps
    By JTAND in forum Revit - Platform
    Replies: 2
    Last Post: 2008-08-29, 04:21 PM
  5. Fascia Mitering Bug.
    By beegee in forum Revit - Known Issues & Work-Arounds (Read only)
    Replies: 0
    Last Post: 2004-01-29, 02:16 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules