Results 1 to 5 of 5

Thread: Pipe labels in sheet manager 2005

  1. #1
    Member
    Join Date
    2003-11
    Location
    Heber, Utah
    Posts
    37
    Login to Give a bone
    0

    Default Pipe labels in sheet manager 2005

    Good afternoon everyone! Does anybody know of issues with 2005 Civil Design sheet manager pipe labels?

    I am producing labels through sheet manager for my plan and profile sheets. I'm not working in 3d yet. Everything looks good until I go to check my inverts. When I check them by hand they do not match what is labeled. My length is 2d in my settings box. Does anyone have any ideas why it is doing this? I've checked everything I can think of.

    Thanks ahead of time for any help

    Stacie

  2. #2
    Civil Engineering Moderator MHultgren's Avatar
    Join Date
    2000-12
    Location
    Indy West (Not West Indies)
    Posts
    1,447
    Login to Give a bone
    0

    Default Re: Pipe labels in sheet manager 2005

    When you calc them by hand, are you going from station to station and then multiplying the distance with the slope? Or are you taking the length that is labelled on the pipe itself and using that to calc your inverts?

  3. #3
    Member
    Join Date
    2003-11
    Location
    Heber, Utah
    Posts
    37
    Login to Give a bone
    0

    Default Re: Pipe labels in sheet manager 2005

    I went by the length and slope to check inverts.

    Last night I found that the length in my pipe editor is not matching the length labeled in sheet manager. I have not figured out why it's doing this.

  4. #4
    Member
    Join Date
    2003-11
    Location
    Heber, Utah
    Posts
    37
    Login to Give a bone
    0

    Default Re: Pipe labels in sheet manager 2005

    I should have explained the way I checked my inverts a little more thoroughly. I started with the invert at the top or bottom of a run. Then I just walked through the run using the labeled distance and slope. When this didn't match, I printed out the pipe editor length and slope for each run. The length did not match the labeled length. If I replace the sheet manager length with the pipe editor length, all of my inverts look good.

  5. #5
    Civil Engineering Moderator MHultgren's Avatar
    Join Date
    2000-12
    Location
    Indy West (Not West Indies)
    Posts
    1,447
    Login to Give a bone
    0

    Default Re: Pipe labels in sheet manager 2005

    What is the 3D length of the pipe compared to what sheet mgr is labelling them at?

Similar Threads

  1. too many sheet manager pipe labels
    By stacie.61594 in forum Civil 3D - Civil Design Companion - General
    Replies: 2
    Last Post: 2006-07-31, 06:24 PM
  2. Sheet Manager Pipe Labels
    By stacie.61594 in forum Civil 3D - Civil Design Companion - General
    Replies: 4
    Last Post: 2005-05-11, 05:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •