Layouts in the Page Setup pull-down

[mfowler]

I currently only use 2 page setups, Full Size and Half Size. Recently my company purchased a KIP6000 so I will be expanding my page setup list. While I'm doing this, I thought it would be helpful to also go ahead and add other setups for various needs (color, pdf, etc.).

My problem is that alot of our projects contain up to 30 layout tabs in a single drawing file. This isn't a problem, but when I want to change the page setup, I have to scroll way down because it lists all of the tabs in there.

Now to my question. Is there a way to force Autocad to not show the other layouts in the page setup pull-down list?

This is for 2004 & 2006. Thanks!

[Mike.Perry]

Now to my question. Is there a way to force Autocad to not show the other layouts in the page setup pull-down list?

Hi

Not as far as I am aware (which means absolutely nothing).

In the meantime take a look at this post - RE: Is there any replacement for BatchPlot in Autocad 04 and 05? - and the Page Setup Routines it mentions, you might find one or two of them very handy...

Have a good one, Mike

[mfowler]

Thanks for the reply. I've seen that thread and found it very useful!