See the top rated post in this thread. Click here

Results 1 to 3 of 3

Thread: Loss of the Z Axis

  1. #1
    Active Member
    Join Date
    2001-12
    Location
    Pittsburgh, PA
    Posts
    71
    Login to Give a bone
    0

    Default Loss of the Z Axis

    Hello,

    I just ran into a problem where if I try to measure in the Z direction, it gives me a distance of 0.00. I think when I tried to do a mirror of a part, my settings went out of whack. I noticed that several other settings where lost as well. What is the command or variable to get this back to normal.

    Thank you

    Paul

    Oops, forgot to mention that I am using MDT 2000i.
    Last edited by paul.stroncek; 2005-10-04 at 06:37 PM.

  2. #2
    Member
    Join Date
    2002-07
    Posts
    16
    Login to Give a bone
    1

    Default Re: Loss of the Z Axis

    Open up power snap dialog and uncheck Ignore Z Coordinate.

  3. #3
    Active Member
    Join Date
    2001-12
    Location
    Pittsburgh, PA
    Posts
    71
    Login to Give a bone
    0

    Default Re: Loss of the Z Axis

    That was it. I could not find it before at all.

    Thank you.

    Paul

Similar Threads

  1. Loss Method
    By drewj in forum Revit MEP - General
    Replies: 2
    Last Post: 2013-09-25, 10:29 PM
  2. 'Section box' in {3D} view can be rotated about X or Y axis as well as Z axis.
    By Wish List System in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2012-02-06, 07:34 AM
  3. New to 2009 and at a loss
    By harkeychad in forum Revit - Rendering
    Replies: 2
    Last Post: 2008-09-05, 03:26 PM
  4. friction loss
    By midas_ in forum AMEP General
    Replies: 1
    Last Post: 2007-03-02, 04:16 AM
  5. Lines on X axis are drawn at varying Z axis
    By s.nail in forum AutoCAD 3D (2006 or below)
    Replies: 16
    Last Post: 2006-09-20, 04:23 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •