Originally Posted by
aledtaylor
Vlad, I had some difficulty following your instructions.
The circle wouldn't extrude along the circular path. I think the angle was wrong. I overcame this by drawing a torus, centred on the centre of the circular path.
I can’t make the segments join up. There seems to be a difference in the angle of the elliptical face at each end or the quarter.
The end view, although very close to circular, is not exactly round. I think an elliptical extrusion path would solve this as it could be made to appear exactly round when viewed from the top.
I expect these problems would not be noticeable with a shallow slope angle.
On the whole, a well thought out process. I particularly liked changing the UCS to draw the circular path.
Aled Taylor
Design Engineer