Setting out co-ordinates

[trevor.tizard]

Hi,

Does anyone know if it is possible to have a block that contains text that will display the co-ordinates of said block depending upon it's location. This would be very useful for setting-out buildings as you could simply locate this block on the points of the building you wanted to set out.

Thanks in advance,



Trev

[Mike.Perry]

Hi

Take a look at FIELDS to accomplish this.

Have a good one, Mike

[Mike.Perry]

Hi

Plus take a look at the following thread...

Block for Northings/Eastings

Have a good one, Mike

[trevor.tizard]

I also have a number of LT seats and was hoping to find a way for those staff memebers to be capable of doing the same.

Thanks.

[Mike.Perry]

I also have a number of LT seats and was hoping to find a way for those staff memebers to be capable of doing the same.

Hi Trevor (I hope I have that correct, please accept my apology if I am incorrect)

Then I think this thread would be better in the ACAD LT General forum.

If you agree, I will happily move it there.

Mike

[trevor.tizard]

Mike,

Think you're probably right..................would be grateful if you could move for me.

Thanks,


Trev

[Wanderer]

Mike,

Think you're probably right..................would be grateful if you could move for me.

Thanks,


Trev

Moving thread from Autocad General forum to this one as it will be better served here. Thank you!