Scaling & Rotating Dynamic Blocks

[kwong]

Hello all,
Dynamic blocks dislike being scaled and/or rotated - they lose their handles. At first I thought I had done something wrong, but I tested the ones that came with the program & found that they behave the same way. Also in some cases moving them by a few metres bring the handles back. Am I the only one who's having this problem?
kwong

[dhurtubise]

What as the one out-of-he-box you tested ?
Did you make sure that you included the action in each one ?

[kwong]

I tested only 2 out of the box - the tree & the car - both of which lost their visibility handles after scaling up by 100 (uniform scaling) & then rotating a few times. It's quite inconsistent - at times it takes only 1 rotation, other times it takes a few.
I just tested the car again and after losing the handle I rotated it 180 degrees & it was OK again!

kwong

[RobertB]

This behavior has been noted before. I would suspect that Autodesk will address the issue soon.

[kwong]

Thankyou RobertB!!!!!! At least I know now I'm not alone.

kwong

[dhurtubise]

I tried reproducing the error, coud not

[kwong]

good morning dhurtubise,
I've saved a drawing which I have problems with - the car on the left has lost its visibility handle the other is OK - have a look .
kwong

[dhurtubise]

Right, got it working here, but still can't reproduce the error

[Mike.Perry]

This behavior has been noted before. I would suspect that Autodesk will address the issue soon.

Hi Kwong

You might be interested in link "AutoCAD 2006 Service Pack 1 Final Release Candidate by Shaan Hurley" found in this post - RE: Breaking info on AutoCAD 2006.

Have a good one, Mike

[kwong]

Thanks Mike,

That's something worth looking at after the weekend - have a good one.
kwong.