Results 1 to 1 of 1

Thread: Back / Front Clipping not saving

  1. #1
    Design Visualization Moderator stusic's Avatar
    Join Date
    Denver, Colorado
    Login to Give a bone

    Unhappy Back / Front Clipping not saving

    Hey All,

    I'm using OBSCUREDCOLOR and OBSCUREDLTYPE in tandem with front and back clipping to create sections and elevations of my model, but whenever I set the back and front clipping, it doesn't save it. It looks good while I'm adjusting it, but when I right-click and click "close", it snaps right back to where it was before. How do I save these clipping planes??

    On an off note: While doing some research, I ran across "HALOGAP". What is this used for?

    Thanks for any help,


    Last edited by stusic; 2005-11-04 at 06:56 PM. Reason: I figured it out.

Similar Threads

  1. 2D Families, different Front/Back & Left/Right
    By ron.sanpedro in forum Revit Architecture - Wish List
    Replies: 2
    Last Post: 2007-09-05, 02:31 AM
  2. Reference Planes / Front and Back....
    By aaronrumple in forum Revit Architecture - Tips & Tricks
    Replies: 4
    Last Post: 2006-02-10, 04:22 PM
  3. Back / Front Clipping precision??
    By stusic in forum AutoCAD 3D (2006 or below)
    Replies: 1
    Last Post: 2005-11-05, 01:39 AM
  4. Bring to front/send to back??
    By Kelly@Laebon in forum Revit Architecture - General
    Replies: 4
    Last Post: 2004-04-30, 10:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts