Results 1 to 5 of 5

Thread: Building Pad and Foundation

  1. #1
    AUGI Addict
    Join Date
    2003-09
    Posts
    1,907
    Login to Give a bone
    0

    Default Building Pad and Foundation

    Laid out foundation, added pad. Now running slab edge on floor (and joined with joined geometry), but Pad not cut by Host Sweep. See attached. Edited Pad to see if it would relook at floor, and the plan view shows the foundation sweep. What am I overlooking to have the pad cut in section by the sweep?
    Attached Images Attached Images
    Last edited by SkiSouth; 2005-07-28 at 02:05 PM.

  2. #2
    AUGI Addict
    Join Date
    2003-09
    Posts
    1,907
    Login to Give a bone
    0

    Default Re: Building Pad and Foundation

    Need input. Is my question clear?

  3. #3
    100 Club steve.70285's Avatar
    Join Date
    2004-06
    Location
    BC, Canada
    Posts
    150
    Login to Give a bone
    0

    Default Re: Building Pad and Foundation

    Skisouth,

    I came up with the same problem.

    I think you'll have to either use multiple building pads with a lesser pad depth under the sweep or change your sweep into an actual foundation wall.

  4. #4
    AUGI Addict
    Join Date
    2003-09
    Posts
    1,907
    Login to Give a bone
    0

    Default Re: Building Pad and Foundation

    Factory, is this true?

  5. #5
    Member
    Join Date
    2004-08
    Posts
    2
    Login to Give a bone
    0

    Default Re: Building Pad and Foundation

    Am using Revit 7.1. Have created a foundation using floor option for creating grade beams with extrusions. Slab was created an in place extrusion to turn on/off visibility of slab and/or grade beams.Slab edges were also created as in place sweeps. Grade beams, slab and slab edges were all joined with join geometry tool. A building pad was added. All building sections and detail views of the grade beams appear correctly in view with the fill pattern of the pad cut correctly by the grade beams. However, print pre-view or a printed hard copy does not actual cut the pad. Any clues?

    Many thanks for your help.

Similar Threads

  1. ME430-3U: Using Green Building XML (gbXML) for Building Energy Analysis Interoperability
    By Autodesk University in forum MEP Design and Engineering
    Replies: 0
    Last Post: 2015-08-07, 05:35 PM
  2. ME427-2: Using Green Building XML (gbXML) for Building Energy Analysis Interoperability
    By Autodesk University in forum MEP Design and Engineering
    Replies: 0
    Last Post: 2015-08-07, 05:35 PM
  3. 2013: Offset Foundation from Foundation Wall
    By ROBP-RDS in forum Revit Architecture - General
    Replies: 4
    Last Post: 2013-09-19, 04:19 PM
  4. 2012: Foundation tag aligning with foundation edge
    By thanus857097 in forum Revit Structure - General
    Replies: 1
    Last Post: 2012-01-10, 08:08 PM
  5. Building/foundation first...then toposurface!?
    By breaksix in forum Revit Structure - General
    Replies: 2
    Last Post: 2010-09-08, 12:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •