Does anyone know if there is any way or routine to make the "list command" return information in decimal feet while using arch. units?
Thanks
|
Does anyone know if there is any way or routine to make the "list command" return information in decimal feet while using arch. units?
Thanks
I'm going to move this from the Tips & Tricks forum, as I believe it will be better served here, thanks!Originally Posted by morgant
Melanie Stone
@MistresDorkness
Archibus, FMS/FMInteract and AutoCAD Expert (I use BricsCAD, Revit, Tandem, and Planon, too)
Technical Editornot all those who wander are lost
HiOriginally Posted by morgant
The following thread should give you some ideas ( Hint - cvunit )...
Area in metric from English units drawing
Have a good one, Mike