Results 1 to 2 of 2

Thread: Contours with flat spots

  1. #1
    I could stop if I wanted to Clyne Curtis's Avatar
    Join Date
    Provo, Utah
    Login to Give a bone


    I imported topo into a project, and where the contours cross a drainage swale they are flat instead of following the original contours. Is there a breakline option in Revit? If not...any suggestions on how to fix?


    Attached Files Attached Files

  2. #2
    Early Adopter sbrown's Avatar
    Join Date
    Coast to Coast
    Login to Give a bone

    Default Re: Contours with flat spots

    Revit isn't particular good with swales and remember the site in revit in mainly a design aid, it is not to take the place of civil drawings. You won't beable to get exactly what you want (you can always draft over any areas that aren't quite right.)

    That being said, try picking the topo surf and adding another point at the elevation of the contour line right in the middle of the flat area and just to the right(make it slightly higher elevation, then push it around and see if you can get the "V" shape you want.
    Attached Images Attached Images
    Scott D. Brown, AIA
    Senior Project Manager | Associate


Similar Threads

  1. 2014: Spots in rendering
    By dylanyoungmandolin617614 in forum Revit - Rendering
    Replies: 1
    Last Post: 2014-04-10, 02:00 PM
  2. Render spots (big ones...)
    By Grumple in forum Revit - Rendering
    Replies: 4
    Last Post: 2009-09-28, 06:34 PM
  3. Anotacion de los Spots Elevation en un Perfil
    By mbravo.212449 in forum Español - AutoCAD Civil 3D
    Replies: 2
    Last Post: 2009-05-17, 02:19 PM
  4. Reflection Spots When Rendering
    By Double 'A' in forum Revit - Rendering
    Replies: 1
    Last Post: 2008-05-16, 06:19 PM
  5. i see spots.....
    By FOUTJM in forum Revit Structure - Wish List
    Replies: 0
    Last Post: 2007-02-26, 09:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts