When copying certain blocks certain objects loose their display order
|
When copying certain blocks certain objects loose their display order
does this help? ID: TS50845 - DRAWORDER command does not work in xref drawingsOriginally Posted by r_soula
(see below under 'similar threads' feature)... I realize this says x-refs, but, from what I understand from what I read, it is affected after you bind the ref, turning it into a block
Melanie Stone
@MistresDorkness
Archibus, FMS/FMInteract and AutoCAD Expert (I use BricsCAD, Revit, Tandem, and Planon, too)
Technical Editornot all those who wander are lost
I have and instrumentation block with lines in it that always go behind the hatch.
I can copy it all over the place if i start from scratch
But if I use it other than from when I start a dwg from scratch it looses its DR
I wouldn't think that would have anything to do with xrefs
Hi
What happens if you use the command _.RegenAll ?
Is correct DrawOrder restored ?
Have a good one, Mike
Problems still accurs with regen all
Yes it is
Hi
Sorry, I am a little confused here ( your responses to my above questions, shown in blue below )...
What happens if you use the command _.RegenAll ? Problems still accurs with regen all
Is correct DrawOrder restored ? Yes it is
Please clarify.
Have a good one, Mike
Sorry,
Yes, that is the case
Hi
Is it possible to post an example of a Block that exhibits this behaviour ie Loses it's DrawOrder when Copying.
Have a good one, Mike
How do you post a block?
HiOriginally Posted by r_soula
Try here...
What Are Attachments?
If still no luck, please post back ( I will then try to explain some more ).
Have a good one, Mike