Can you import the layouts to a new drawing via the Design Center? Does LT have that feature?Originally Posted by Ms. Serene
|
Can you import the layouts to a new drawing via the Design Center? Does LT have that feature?Originally Posted by Ms. Serene
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
Do any of these posts on the Autodesk Discussion Groups help?Originally Posted by Ms. Serene
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
I have tried using design center as a possible solution and it works fine until i hit that one reference file.... I honesly think it might be an object enabler problem but i can't find the one that will work.... the one that Autodesk says will work will not load because i don't have 2000i...Originally Posted by Opie
thanks for the posts... i had been looking at them earlierOriginally Posted by Opie
they appear to have had the same problem and went through the same steps to try to fix it... unfortunately if they found the fix they didn't post it