I have been trying to find a routine that will allow you to define a mline with pline that has arcs. It for creating a water main and sewer that has a greater dia. then 30". The engineer wants it to appear double line.
I know most people hate mlines to do this, but I prefer it, mainly for the ability to update the edges and center line all at the same time without making a selection set. however, I have never had to use it to create a line that is over 5 mi long.
What I am looking for:
-Define a path with a pline
-Cut the mline in 18' or 20' sections along the arc connecting end to end and at the furthest end before going to a straight connecting to the end point of the arc.
If I can't find it I might just have to write it at home then bringing it to work for use since I don't have the time to do it at work.
Any suggestions?