Results 1 to 2 of 2

Thread: Vessel Elliptical Head Creation

  1. 2006-05-24, 02:05 AM #1
    lenandcoll
    lenandcoll is offline
    Woo! Hoo! my 1st post
    Join Date
    2006-05
    Posts
    1
    Login to Give a bone
    0

    Post Vessel Elliptical Head Creation

    Does anyone have a recommended procedure to create 3D elliptical heads for vessels, in AutoCAD 2007?

    Thanks,
    Len
    Reply With Quote Reply With Quote
  2. 2006-05-24, 12:15 PM #2
    jaberwok
    jaberwok is offline
    Certified AUGI Addict jaberwok's Avatar
    Join Date
    2000-12
    Location
    0,0,0 The Origin
    Posts
    8,570
    Login to Give a bone
    0

    Default Re: Vessel Elliptical Head Creation

    I use a quarter ellipse (after setting PELLIPSE=1). Close it off with two lines, PEdit/Join then Revolve.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 2014: Section Head - Stagger Offsset Callout like Grid Head
    By Limbatus in forum Revit Architecture - General
    Replies: 2
    Last Post: 2014-11-27, 01:08 AM
  2. 2012: Placing a vessel connection pipe flange
    By cdixon374626 in forum Inventor - General
    Replies: 1
    Last Post: 2013-05-20, 02:45 PM
  3. CP319-3: AutoCAD® Programming Gurus Go Head-to-Head
    By Autodesk University in forum Customization and Programming
    Replies: 0
    Last Post: 2013-05-05, 01:37 PM
  4. CP23-1: Programming Gurus Go Head-to-Head
    By Autodesk University in forum Customization and Programming
    Replies: 0
    Last Post: 2013-04-08, 07:13 PM
  5. Vessel Re-pad
    By clarkrj in forum AutoCAD 3D (2007 and above)
    Replies: 0
    Last Post: 2007-08-15, 06:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules