I'm getting this warning about sketch lines being slightly off-axis, on just about every single sketch line I'm drawing in my details. I'm assuming this comes from the fact that True North is rotated to 45.xx degrees, just a few tenths off from 45? What am I supposed to do about it? That's how the site is actually oriented.

My property line bearings read like: S 45* 29' 53" E and S 44* 30' 07" W (two right-angle property lines), and the building is oriented parallel to those lines.

So am I just doomed to getting these slightly off-axis errors about eleventy-billion times throughout the duration of this project?