|
|
Rogue Analytical lines
Hi,
I had to make a custom column family for a project i am doing.
It all worked as expected apart from the analytical line which shoots down to the Z=0 level and I can't figure out how to get it to stop at the base of the column.
Any help is much appreciated.
P.S. Revit 4
Regards
Clinton
Re: Rogue Analytical lines
Clinton,
Does it have to do with the Bottom Vertical Projection parameter's value? If you're not sure, check the properties of the column, under the Analytical Model category you'll see that parameter.
It seemed to work fine when I used it but I did notice that those values were set to "Auto-detect" so maybe that's what is getting you?
Re: Rogue Analytical lines
Thanks Rick,
Very strange, after I read your post I inserted the column into a new project and then back into my current project and both seemed to work fine, but no matter what I did i couldn't get the existing ones to right themselves. I think I'll just delete them and reinsert them and hope I don't do whatever I did before to screw them up.
Cheers for the advice.
Clinton
Re: Rogue Analytical lines
So anyway, I think I figured it out.
refer attached
Posting Permissions
Reply With Quote