Selecting edges V11

[mike.115370]

In Inventor v10 I can select edges even though they are hidden for carrying out project geometry, filleting etc. In this case when I hover the cursor over where the hidden edge is it 'lights' up and I can select it. I've just loaded V11 and it does not do this. To select an hidden edge I need to F4 and change the view angle. Does anyone know if a variable has been added or set differently in V11?

[jonathan.landeros]

In Inventor v10 I can select edges even though they are hidden for carrying out project geometry, filleting etc. In this case when I hover the cursor over where the hidden edge is it 'lights' up and I can select it. I've just loaded V11 and it does not do this. To select an hidden edge I need to F4 and change the view angle. Does anyone know if a variable has been added or set differently in V11?

To the best of my knowledge, nothing in this area has been changed. Are you sure that your selection filter isn't set to something other than Faces and Edges? (You can change the filter by holding down the shift key and right clicking)

[mike.115370]

Thanks I,ve just done this and turned the select sketch features on and it works.

Cheers
Mike