new user

[clark123]

Hello, not sure if i'm doing this posting right, but we'll see if it works. I also am relatively new to aCAD and not making very good progress.

[Mike.Perry]

Hello and welcome

Give it time, with learning, practice, asking questions... you will get there... just need to stick with it.

Within the AUGI Forums you will find a lot of helpsul / useful information... if you can not find what you are after, simply post a question in a new thread. Normally there is at least one person that can help ( more often that not, you will find there is more than one person who can offer help / guideance / etc ).

Plus, have you taken the time to browse the Education area on AUGI.com

You will also find lots of helpful / useful information within the Publications area of AUGI.com

Mike

[blads]

Hello, not sure if i'm doing this posting right, but we'll see if it works. I also am relatively new to aCAD and not making very good progress.

Greetings from downunder & welcome to the AUGI forums...

You might wish to check out the ATP forums since you're relatively new to CAD - where you can get the best AUGI training programs in the known universe and stop by Coffee Without Cad for some laid back fun!!

[CGM]

Hello, not sure if i'm doing this posting right, but we'll see if it works. I also am relatively new to aCAD and not making very good progress.

Hello Clark123,
Welcome to AUGI; I my self made pretty slow progress, at first with Autocad, that was 20 years ago now ( September 1986 ). Stick at it, it will become second nature.

What version are you learning?

[Opie]

Welcome to AUGI. Your first post looks good.

For some additional reading on the AUGI Forums, you might try this thread, "*** New Forum Users please read and take note ***". For some additional Tip & Tricks, you might try out the Forum Tips & Tricks.

Richard

[BrenBren]

Hello Clark123,
Welcome to AUGI; I my self made pretty slow progress, at first with Autocad, that was 20 years ago now ( September 1986 ). Stick at it, it will become second nature.

What version are you learning?

wow... I wasn't even out of high school yet

[Steve_Bennett]

wow... I wasn't even out of high school yet

I wasn't even close to being done with GRADE school...

[Sammie]

I wasn't even close to being done with GRADE school...

sheesh. I had just turned the good 'ole age of 1 in '86

Welcome new augieer! enjoy your stay and remember to hop on over to the Coffee Without Cad forum for some laid back fun!

Samantha
CWC Moderator

[Steve_Bennett]

sheesh. I had just turned the good 'ole age of 1 in '86

Thanks for making me feel even older.

[Sammie]

Thanks for making me feel even older.

no Problem Steve...here have another