Batch Plot & Aerials

[Aquaserpent]

Greetings,

I'm having a little trouble plotting a set of plan/profiles that have aerials attached to them. When I plot manually they plot fine at a size of 80 – 90 Megs. When I try to utilize the Batch Plot utility my plots are only 8 KB in size, I have not sent them to the plotter because I do not believe there is anything on them. Has anyone run into this problem before, and does anyone have a solution? Thank you in advance for your attention to this matter.

[Mike.Perry]

Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS75703 - Raster images do not plot with Batch Plot utility

Have a good one, Mike

[Aquaserpent]

Thanks Mike,

This issue refers to an aerial attached to an external reference. This is not my condition, I have the aerials in the drawing I’m trying to plot. I fixed the problem by selecting a non-system plot driver, one I had created from the system plot driver. Again thank you for your assistance in trying to get to the root of the problem.