Regarding the Tutorial for "Precast Concrete" subsection "Adding Beam Stystem
to the STructure".
I question whether or not this part of the tutorial is behaving properly. On my end when following the steps indicated it will place the beam system with the two end tees missing. Not like shown in the picture. If I set layout to "Fixed Distance" and put in a value of 8'-1", it will place tees per the tuturials picture.
To me something seems wrong with the "Clear Spacing" setting. By setting it to 1" clear spacing the beam system exceeds the extent of the allow space of its boundry, thus leaving the end ones out??
Setting the clear spacing to zero will place all tees, but will not overlap the grid as shown in section. Makes sense since they do not exceed the beam system boundary.
Can anybody else produce thes results?
thank,
jamie