AutoCAD 2007 to 2005 - ARX_ERROR: eNotThatKindOfClass

[droach]

Help. I have a drawing from AutoCAD 2007saved down to 2005 but when I try to do any commands (such as move or copy etc.) I get an: ARX_ERROR: eNotThatKindOfClass
error. Is there any way to remedy this?

Thanks

[jaberwok]

This thread may help.

[droach]

Thanks, but the hotfix did not work with this. Still cannot do any commands in 2005 drawing. Any other ideas?


Thanks

[rkmcswain]

Help. I have a drawing from AutoCAD 2007saved down to 2005 but when I try to do any commands (such as move or copy etc.) I get an: ARX_ERROR: eNotThatKindOfClass
error. Is there any way to remedy this?

Thanks

Is there a vertical product involved here or is this vanilla AutoCAD?

[Brian Myers]

You could perhaps try DWG Trueconvert
http://usa.autodesk.com/adsk/servlet...&siteID=123112

Just be sure to read the frequently asked questions before you use it...

[Mike.Perry]

Help. I have a drawing from AutoCAD 2007saved down to 2005 but when I try to do any commands (such as move or copy etc.) I get an: ARX_ERROR: eNotThatKindOfClass
error. Is there any way to remedy this?

Hi

Take a look HERE and HERE.

Plus, try plugging the following search criteria in the forum search facility...

Key Word(s): eNotThatKindOfClass

Have a good one, Mike