Bolts Nuts Screws & Nails

[ford347]

There are common nails located in the rough framing portion of your detail components. Here it is, it has all nail sizes so it's pretty useful. I also threw in an SDS screw, looks good. I have a bunch of simpson hardware too.

Josh

[david.metcalf]

I am unable to get these into my section or elevation or detail views only in the drafting views. How come that is the case?


Thanks
David

After dropping in to drafting view, I was able to copy/paste to detail view. Wonder if it is somewhere in the model?

[sujeevtk187479]

Hi

I was searching for a pipe support clamp and bracket. i couldnt get that. accidently i see this so i thought may be you can help me with this. i have pipes ranging from 50 dia to 300 dia. so could you please tell me where can i get this?? basically i am looking for HILTI clamp and unistrut. hope you can help me.

Thanks and regards

[jsteinhauer]

i have pipes ranging from 50 dia to 300 dia. so could you please tell me where can i get this?? basically i am looking for HILTI clamp and unistrut.

You might want to post your request in the MEP forum as well with a hyperlink back to this thread. For myself, I created the unistrut profiles long ago, that I use in sweep as profiles when needed. I don't get into the clamps & other connections to often.

Cheers,
Jeff S.

[emmanuel790049]

Will these do... I can't remember where I got them from

It brings very fond memories and sadness to see this great contribution by "uncle" Bill. Unfortunately, he's no longer with use. Rest in peace, mate!

Warm regards from Southern California,

Emmanuel A. Garcia
Past AUGI President and Fellow Founding Director

[Mary-Terra-2022]

THANK YOU. It is amazing how difficult it is to find a simple lag bolt drawing in 2D. Again thank you.

[Ed Jobe]

If you can get one in 3D, just use the VIEWBASE command to get a 2D view of it. The FLATSHOT command may also work.