Equal spacing of mullions as Dynamic Block is stretched

[.chad]

in the attached block, i have gotten 4 out 5 of the mullions (muntins? i can never remember) to move proportionally as the block stretches, but the 2nd one from the bottom seems to stick. any ideas?

[Chris.N]

in the attached block, i have gotten 4 out 5 of the mullions (muntins? i can never remember) to move proportionally as the block stretches, but the 2nd one from the bottom seems to stick. any ideas?

it's in 2007, isn't it?

[.chad]

it's in 2007, isn't it?

oops fixed. i forget some of you are still way back in last year.

[Chris.N]

oops fixed. i forget some of you are still way back in last year.

not by choice, but thanks!

[Chris.N]

oops fixed. i forget some of you are still way back in last year.

you must have had that move associated with the static end of the parameter, erase and reassociate to the moving end, and you'll be good!

[.chad]

you must have had that move associated with the static end of the parameter, erase and reassociate to the moving end, and you'll be good!

the static end is the base point of the linear parmater right - the end without a blue arrow? ive tried reassociating it a couple times now, and unless its stopping to the wrong end at the last second, its set up for the top =/

edit - hm. i just tried it again and it worked. /shrug thanks =)

[Chris.N]

the static end is the base point of the linear parmater right - the end without a blue arrow? ive tried reassociating it a couple times now, and unless its stopping to the wrong end at the last second, its set up for the top =/

edit - hm. i just tried it again and it worked. /shrug thanks =)

i've had actions do the 'instant switch' to me more times than i care to admit, it must be a funky 'osnap' thing....

[binh]

I tried to learn from this post, but I could not open Chad_C drawing. I have Cad 2006.
In the HR block I have, I tried to stretch and keep the mid post at center. How can I do that?
Thanks in advance.

[Opie]

I tried to learn from this post, but I could not open Chad_C drawing. I have Cad 2006.
In the HR block I have, I tried to stretch and keep the mid post at center. How can I do that?
Thanks in advance.

Check his Chad's second post in this thread. He converted it down.

[Rico]

I tried to learn from this post, but I could not open Chad_C drawing. I have Cad 2006.
In the HR block I have, I tried to stretch and keep the mid post at center. How can I do that?
Thanks in advance.

liike zeees?