ok I have almost wrapped up my DD package and I just meet with the architect.
The biggest problem that he had over and over again was with lineweights.
The title sheet and the floor plans look great but....
The site plan and the elevations the lines are way too thin. It does not pop!
On the sections the lineweights are way to thick
My floor plans and elevations are at 1/8"
The sections are at 1/4"
The stud and finish are bleeding together on the sections
How can I make the section lineweights thiner.
His title block and title sheet normally have a big fat 1/4" thick line on it.
But with rivit the thickest detail line that I can do is like a .025
How can I get thicker drafting lines.
How can I get the site plan and elevations to have thicker linework.
I need the outline of the sections to be thick.
He also wants the outline of the building to be a hidden line on the site plan.
How can I do that? If I turn on the walls then its a double line?