Results 1 to 3 of 3

Thread: Updating Templates to have Fields

  1. #1
    Member
    Join Date
    2004-06
    Location
    OHIO
    Posts
    33
    Login to Give a bone
    0

    Question Updating Templates to have Fields

    To all who may help,
    I have numerous templates to update and I have run into a little problem I think. Ok, here is the problem. My templates show up with ###### this where my fields are. Now this is when I just open my templates and not when I create a new drawing from a Sheet Set. I read that they are supposed to show as whatever you have placed in the default value. Is this supposed to happen or is there a problem going on. I follow all the steps and all of my templates end up with those pound symbols. Well everyone except for 2 out of the 12. If you want me to list what steps I go threw I will. PLEASE HELP!!!!

  2. #2
    AUGI Addict
    Join Date
    2015-12
    Location
    Arizona
    Posts
    2,478
    Login to Give a bone
    0

    Default Re: Updating Templates to have Fields

    As they work correctly when you actually use them
    I would accept them as they are.

    However this document explains the problem and solution clearly
    enough: http://usa.autodesk.com/adsk/servlet...linkID=2475176

  3. #3
    Member
    Join Date
    2004-06
    Location
    OHIO
    Posts
    33
    Login to Give a bone
    0

    Default Re: Updating Templates to have Fields

    Well I believe I found out why. My .dst file was in a different location then where my templates were being held at. So I moved my templates in the same location as the .dst files.

Similar Threads

  1. Fields in DB not Updating
    By stusic in forum Dynamic Blocks - Technical
    Replies: 9
    Last Post: 2012-02-16, 03:19 PM
  2. Updating view templates
    By patricks in forum Revit Architecture - General
    Replies: 5
    Last Post: 2009-04-29, 07:11 PM
  3. Fields not updating in DB
    By abouzane in forum Dynamic Blocks - Technical
    Replies: 1
    Last Post: 2008-04-03, 06:32 PM
  4. Fields not always updating
    By KGC in forum AutoCAD Customization
    Replies: 2
    Last Post: 2007-11-21, 12:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •